One Shot Universal BWT

Characteristic :                        

• Convenient liquid treatment, which provides the basic alkalinity on which successful water treatment depends.

• Provides optimum conditions for hardness control to function.

• Neutralizes acid conditions.

• Will assist in keeping silica in suspension.

• Simple test to determine level of treatment.

• Can be used in boilers of all pressures

• Can be used as a neutralizer after acid cleaning operations

• Dispersant action suspends sludge and sediment particles for efficient blow down.

• Oxygen scavenging for optimum protection

• Protects boiler, steam lines, condensate lines and feed water lines from corrosion                              

• The dosage rate is dependent on boiler operating condition, feed 2-3 ltrs of RXSOL-50-5001-020 solution for per thousand of boiler water then control the system by periodic Alkalinity test procedure.
• If p-Alkalinity is below 200 ppm increase the ratio of RX-SOL 6WT 5001 solution.
•  If p-Alkalinity is above 400 ppm reduce the concentration of RXSOL-50-5001-020 solution by dilution with water. RXSOL-50-5001-020 is strongly alkaline.
•  RXSOL-50-5001-020 is best applied heat or diluted with any convenient strength on a continuous basis using a suitable chemicals pump.

          Dose:

• Control is by simple boiler water tests or RX Cleansers can provide a suitable test kits for this purpose. Used in low pressure and auxiliary boilers 

Procedure for p-Alkalinity test  Step wise I:

• 
  

  Measure  10 ml of Sapless Water in graduated Tet Tube Cylinder

• Add 1-2 drops of RX SOL TK7 and mix with the stirring rod ,If sample turns red! PINK( which indicates presence of p-Alkalinity ) then follows 3'd step otherwise if sample remains colorless ( Record = 0) .

• Add RX SOL TK9 drop by drop ( by counting ) , mixing with the stirring rod until color just disappears. Each drop is equivalent to 25 ppm of p-Alkalinity , expressed as CaCO3

• Result Each DROPS is equivalent to 25 PPM of Alkalinity.

 

 

Procedure for p-Alkalinity & total alkalinity  step wise:

• Measure 10 nil of Sample Water in graduated test tube i cylinder                                           

• Add 1-2 drops of RX SOL TK7 and mix with the stirring rod , If sample turns red]' PINK ( which indicates presence of p-Alkalinity ) then follows 3'd step otherwise if sample remains colorless ( Record p-Alkalinity = 0) then proceed to Step- 4,

• Add RX SOL TK9 drop by drop (by counting), mixing with the stirring rod until color just disappears. Each drop is equivalent to 15 ppm of p-Alkalinity , expressed as CaCO3

• Add 2-3 drops of RX SOL TK8 and mix with stirring rod , the sample will turn to bluish-peen .

• Add RX SOL TK9 carefully by counting drop by drop and mixing thoroughly until alight reddish pink color develop.                                         

• Carpet Shampoo
• StainlessSteelPassivatingPickling Paste
• Concrete Sealer
• Cement Remover
• Rigwash
• Drain Pipe Cleaner
• Aluminium Cleaner
• Floor Cleaner
• AirCooler Cleaner
• Rust Remover
• HighTuff Foam

• Glass Cleaner
• Brass Cleaner
• Toilet Cleaner
• Coil Cleaner
• Dish Wash
• Chlorine Tablet
• SuperiorWaterlessHand cleaner
• Coal Remover
• Degreaser HD
• Electrosol
• Paint Remover