Product Dose

First of all flush the system with cold water to prevent evaporation rates and polymerization then the most economical method of using RXSOL G:50,  is by direct injection followed by recirculation washing, using tank cleaning machines. Spraying Method  - Using RXSOL G:50 as delivered in drums, spray onto areas where residue remains following rough washing leave for 10-45 minutes (but do not allow to dry), then butterworth at maximum pressure and warm water 60oC for at least 3 hours, checking that there is no foam remaining in the final stages.  Inspects tanks(s) and if desired result has been achieved fresh water rinse and dry.

** Make sure to take all safety precautions are followed when handling / spraying RXSOL G:50**

Injection Method – not applicable.

Re-circulation Method :

Fill tank with fresh water and heat up to warm 50 oC .IF a drop line is available on the tank line system, then start to circulate the water and add the required amount of RXSOL G:50 make a 2.5 to 5% solution.  Under normal circumstances, between 2.5% and 4.5% will be sufficient strength.  If there is no drop line, then lower butterworth hoses into the tank from the pump stack header without machines attached and circulate through these hoses while you fill the solution material.